View source for Logitech Wireless Headset Cutting Out

After all that... I think those settings are for equalization

 *sigh*


Ran into this issue a few years back when we had our 2.4Ghz wireless AP close to the USB receiver for a Logitech G930 headset: the headset would beep and cut out a lot (lose connection).  Very inconvenient\annoying\etc.  I ended up disabling 2.4 on the AP because I had other ones in the house I could run.  This weekend we upgraded the wireless AP and due to what we were doing (getting rid of the old APs), I needed 2.4Ghz to be enabled from the new device.

If you have the options to lock in your wireless 2.4Ghz channel, consider the following:

=Wireless AP=
* Lock the 2.4Ghz into a channel.  I chose 11 for our house where we only have the 1 AP running.  If we put in a second, I'll look at 6 for that one.  We should never have a 3rd here.  This usually can be done in the admin panel of the device, sometimes under Advanced.

=Logitech=
* Make sure you are running Logitech drivers (if not, I am not sure where Windows default driver controls this).
** I am using g930_100364b_x64.exe
* Set the headset to using channel 1 using Regedit (example below)
<pre>
Windows Registry Editor Version 5.00

[HKEY_CURRENT_USER\Software\Logitech\G930]
@=""
"Band1GainLevel"=dword:00000001
"Band2GainLevel"=dword:00000000
"Band3GainLevel"=dword:00000000
"Band4GainLevel"=dword:00000000
"Band5GainLevel"=dword:00000000
"Band6GainLevel"=dword:00000000
"Band7GainLevel"=dword:00000000
"Band8GainLevel"=dword:00000000
"Band9GainLevel"=dword:00000000
"Band10GainLevel"=dword:00000000
</pre>

* Restart Windows

Note: this is a per user setting in the registry.  Multiple profiles will need to have the regkey set. 

[[Category:Windows]]
[[Category:Weblog-2019-12]]