Distant Screws II Challenge Coin: Difference between revisions
From Mike Beane's Blog
m (→Download) |
m (→About) |
||
| Line 1: | Line 1: | ||
==About== | ==About== | ||
Placeholder | |||
[[File:DS2-Heads.jpg|thumb]][[File:DS2-Tails.jpg|thumb]] | [[File:DS2-Heads.jpg|thumb]][[File:DS2-Tails.jpg|thumb]] | ||
==ReadMe== | ==ReadMe== | ||
Revision as of 13:28, 3 March 2021
About
Placeholder
ReadMe
A how-to for printing the 3D LS DS II Challenge Coin for anyone that was on the 2021 Distant Screws II Expedition.
The front-side features the classic LS Logo, the expedition name, dates and the waypoint distances traveled.
The backside features the four points of the journey (ROSS310-EVELYNS LIGHT-COLONIA-QAMA) and a star to honor Evelyn Faye Roy.
Printing Suggestions
Scale to 60mm x 60mm x 8mm (or 10mm)
Super Quality
No Infill
1) With trees: On an edge - will require sanding and clean up. 2) In halves:
Duplicate the STL on the bed
Sink both below the bed to 1/2 the Z width (-4mm or -5mm)
Flip one of the faces
Print
Glue together
Sand edge as needed with 220g and 500+
Created by RabbiBob 3/1/2021 w/ Blender 2.9.x
Download
- Download: Zip file 4.5MB