Actions

Distant Screws II Challenge Coin

From Mike Beane's Blog

Revision as of 11:16, 3 March 2021 by Rabbi Bob (talk | contribs)

About

Place holder page


DS2-Heads.jpgDS2-Tails.jpg

ReadMe

A how-to for printing the 3D LS DS II Challenge Coin for anyone that was on the 2021 Distant Screws II Expedition.  

The front-side features the classic LS Logo, the expedition name, dates and the waypoint distances traveled.

The backside features the four points of the journey (ROSS310-EVELYNS LIGHT-COLONIA-QAMA) and a star to honor Evelyn Faye Roy.


Printing Suggestions

     Scale to 60mm x 60mm x 8mm (or 10mm)
     Super Quality
     No Infill

1) With trees:  On an edge - will require sanding and clean up.
2) In halves:
     Duplicate the STL on the bed
     Sink both below the bed to 1/2 the Z width (-4mm or -5mm)
     Flip one of the faces
     Print
     Glue together
     Sand edge as needed with 220g and 500+


----------------------------
Created by RabbiBob 3/1/2021
w/ Blender 2.9.x

Download

Directions

Load video
YouTube
Retrieved from "https://www.mikebeane.com/index.php?title=Distant_Screws_II_Challenge_Coin&oldid=1579"