GNX4 Software
From Mike Beane's Blog
I can't seem to load my USB drivers.
Digitech GNX4 submitted on 2/13/2006
- You will need to uninstall the USB drivers in the device manager
- Go to control panel, system, device manager, sound video and game controllers
- Click the plus button & verify the GNX4 is connected and turned on.
- Uninstall all 5 digitech drivers or USB audio devices.
- Verify you uninstall the correct drivers.
- Call 801-566-8800 if you are not sure, and we will help you!
- After you uninstall the drivers turn off the GNX4
- Unplug the USB cable from the GNX4
- Perform a factory reset on the GNX4
- This procedure is in the manual.
- Reconnect the GNX4 this is a very important step
- Watch your computer screen on the bottom right hand corner
- it will say found new hardware then you will get a lot of pot up window
- wait until the last one says Your new hardware is installed and ready to use
- Now put the X-Edit/Librarian disk into your computer
- Run the USB midi drivers
- follow the GNX4 software installation guide.